Call Us
Every layer your home needs to hold the line
One assessment, one plan, built around your property. From the coating that hardens your home's surfaces to the extras that close the gaps — here's everything WildfireShield can do, in detail.
WHAT WE SERVE
Every property carries risk differently — a hillside acreage in the Okanagan isn't a townhouse in the Valley. We start with a walk-through, then build protection in layers. Coating is the core; everything else is added only where your home actually needs it.
01
COATING
02
SPRINKLERS
03
EMBER GUARDS
04
MAINTENANCE
05
COMMERCIAL
COrE Service
FIRE-RESISTANT COATING
Our foundational service: a professional, hand-applied coating for the surfaces where embers actually land and ignite a home. Under heat it expands into the material to starve the flame of oxygen, then contracts back so your home is preserved — ready for the next season, not sacrificed after one.
Applied to roof, siding, eaves, decks and exposed structural wood
Works on wood, stucco, fibreglass siding and wood/composite shingles
Reusable protection that holds through multiple heat events
Full surface prep — masking and plant protection — included
ADD ON
PERIMETER SPRINKLER & MISTING
A heat-triggered system that pre-wets your roof and perimeter as fire approaches — raising humidity and cooling embers on contact before they can take hold. Designed to run from on-site water storage, so it keeps working even when the grid goes down.
Heat-activated roof and perimeter coverage
Runs from dedicated on-site water storage
Independent of grid power during an event
Pairs with coating for layered protection
ADD ON
VENT & EMBER GUARDS
Embers don't just land on surfaces — they get inside, through vents and openings the coating alone can't seal. We fit fire-resistant screening and guards around eaves, crawlspaces and structural openings to close off the gaps where embers slip in.
Fire-resistant screening for vents and openings
Eave, soffit and crawlspace coverage
Closes the ember-entry gaps coating can't reach
Assessed opening-by-opening for your home
ON GOING
SEASONAL MAINTENANCE PLAN
Protection isn't a one-time event. Before each fire season we return to re-inspect your coating, check the high-exposure areas, and touch up where weather and wear have taken their toll — so your home stays as protected in year three as it was on day one.
Annual pre-season re-inspection
Touch-up of high-exposure surfaces
Check on guards, vents and add-ons
A written record kept current each year
CUSTOM SCOPE
ACREAGE & COMMERCIAL
Larger properties carry more than one building's worth of risk — outbuildings, fences, decks and boundaries all matter. We scope acreage, strata and commercial properties individually, planning coverage across every structure rather than treating the main house alone.
Multi-building and outbuilding coverage
Fences, decks and boundary structures included
Strata and commercial scopes welcome
Planned and quoted as its own custom project
WHY OUR COATING IS DIFFERENT?
Most fire coatings are intumescent — built for commercial steel and designed to be sacrificed once. Ours is built for homes, and built to last.
TYPICAL INTUMESCENT COATING
Hardens permanently when heated
Leaves treated wood charred and unsalvageable
Reapplied after a single event
Needs a thick 15–20 mil coat
Built mainly for commercial structures
WILDFIRESHIELD COATING
Expands, then contracts back to original state
Wood and stucco preserved, not damaged
Holds through multiple heat events
Effective at a thinner 3–5 mil application
Designed for homes and the wildland–urban interface
Not Sure Which Service You Need?
No worries — that's what we're here for. Get a free inspection and we'll identify the problem and recommend the right solution.
Professional wildfire coating for BC homes — the next step after FireSmart, built for the Fraser Valley and Okanagan.
Get in Touch
Call Us
Copyright © WildFireShield 2026. All Rights Reserved.